Vertrel^® cleaning agents are extremely stable and can be used for weeks or months inside a well-tuned vapor degreaser. Since the solvent is constantly being distilled and recycled, it remains clean and pure indefinitely. There is no need to perform acid acceptance tests or check the specific gravity of the solvent, as there is with solvents like nPB or the old-style chlorinated solvents.

So when do you change the solvent? Hardly ever. The real issue is not the solvent which remains clean and pure indefinitely, but when the machine becomes too dirty to operate efficiently.

In a standard degreaser, the contamination accumulates in the boil sump. This is the first chamber in the cleaning cycle. It is the spot into which the dirty parts are placed when they first go into the machine, and it is here where the worst contamination will aggregate.

In general, the boil sump on a busy machine should be cleaned quarterly. Symptoms to watch for include a change in the color of the solvent. The solvent in the boil sump will have a high concentration of dissolved contamination, to the point of tinting the solvent yellow or beige. Additionally, at the bottom of the boil sump will be a large collection of insoluble junk -- like solder balls, metal filings, labels and chewing gum -- which will need to be removed. It's time to clean the machine.

Cleaning a degreaser normally involves a process called boil-down. This simply involves distilling (boiling) all the solvent out of the system and -- rather than returning it to the rinse sump -- recapturing it in a pail or a drum for re-use. When only a few liters of solvent remain at the bottom of the boil sump, the heat is turned off. Any residual waste solvent and the solid contamination is cleaned out by hand and disposed of as a hazardous waste. The whole process may take a day on a big and dirty machine.

In more sophisticated machines, a recirculating pump is installed on the boil sump to refresh the solvent in the boil sump and to remove particulate. This will extend the periods between boil-downs.

Once the machine is ready to be returned into service, the old (but clean) solvent which was recaptured during the boil-down process is dumped back into the machine.

Check with you machine manufacturer for their thoughts and recommendations.

Please call, fax or email us at Micro Care Marketing Services
for more information about our full line of cleaning answers.